Products:
Where to Buy:
Click here for secure online ordering of Screen Curtains
Installing the Screen Curtain
The Screen Curtain comes in a small lightweight kit. In this illustration, the gray screen kit comes with 4 mesh panels (6 panels in the other color kits) each measuring approximately 11 inches wide. All mounting hardware is included
The only tools needed to install the curtain are a Philips screwdriver, tape (optional), and drill (optional)
Gray kit shown below
The end brackets may be mounted above or on the door frame depending on the type of door. This example shows a typical 6 ft sliding glass door frame with the end bracket mounted on the wall surface above the frame.
The number of center brackets used will depend on the width of the screen curtain. Each kit contains two center brackets.
NEXT: Cut the strip to the desired width using a hack saw or other fine tooth saber saw. Straighten the panels on the floor alongside the black rod and cut them to the size that you need. Remove the yellow protective sticker from the glue strip, attach the weights and secure them with the enclosed retainers.Straighten the panels again (you can use the box)and make them overlap 2 inches. Use the small stickers to secure the panels to the floor. Wrap the tops around the rod with the glue strip, press the rod into the strip and you are done!
Complete !
Now you are ready to start enjoying your screen curtain.
Download PDF Instruction Sheet
